Configure as Master Clicker

A Master Clicker is a special RF Clicker that is used by an instructor to send commands to a Session from anywhere in the room. The only difference between a Master Clicker and a Closed Master Clicker is that the Master Clicker must select and join an Open Class, while the Closed Master Clicker is automatically joined to the Closed Class for which it was configured. As a security measure, before the Master Clicker can be used in the Class, it must be enabled by selecting the Enable Master Clicker option from the RF Menu.

The following table summarizes the Command Key assignments.

KEY	CLICKER DISPLAY	FUNCTION
	START Q	Start the Question Timer. Resume the Question Timer.
	PAUSE Q	Pause the Question Timer.
	STOP Q	Stop the Question Timer.
	+15 SEC	Add 15 seconds to the Timer.
	-15 SEC	Subtract 15 seconds from the Timer.
	INSERT Q	Insert an impromptu Question. (This can be done only when presenting a PRS Lesson.)
	GRID	Show or hide the Response Grid.
	PAGE UP	Page Up – Used during a PowerPoint Session to go to the next slide. (Can also be used with any application that recognizes this command.)
	F5	F5 Function Key – Used to start a PowerPoint Slide Show. (Can also be used with any application that recognizes this command.)
	PAGE DWN	Page Down – Used during a PowerPoint Session to go to the previous slide. (Can also be used with any application that recognizes this command.)
	NEW SESS	Start a new Session. This applies only to PRS Lesson Sessions.
	END Q/S	End Session or End Question. This is the equivalent of clicking on the End Session Function Button to end a PRS Lesson Session, or the End Question Function Button to end a PowerPoint Question Slide.
	SPACE	Enter the Space character at the cursor position.
	LIST	Show or hide the RF Clicker Joined List.
	INSTRUCT	Show or hide the Instructor Window.
	TAB	Issue the Tab command.
	ESC	Issue the ESCape command.
	PREV Q	Go back to Previous Question – used only during a PRS Lesson Session.
	NEXT Q	Advance to Next Question – used only during a PRS Lesson Session.
	ENTER	Issue Enter command. This command is used for processing the OK and default buttons on dialogs.
	CHART	Show or hide the Response Chart.